Page 4 of 19 FirstFirst 1234567891014 ... LastLast
Threads 85 to 112 of 531

Forum: Debugging Your Build

  1. Question 5F1 cathode resistor voltage extremely high

    Started by MonkHouse93, 01-18-2014 07:50 AM
    5f1, bias resisror, blowing up, voltage troubleshooting
    • Replies: 11
    • Views: 2,011
    01-20-2014, 07:04 PM Go to last post
    • Replies: 6
    • Views: 1,314
    01-16-2014, 03:38 AM Go to last post
  2. B15 Preamp issue

    Started by hylaphone, 12-30-2013 10:38 PM
    • Replies: 2
    • Views: 835
    12-30-2013, 11:14 PM Go to last post
  3. 5E5-A low output volume

    Started by Corcia, 11-22-2013 09:33 AM
    • Replies: 29
    • Views: 3,013
    12-16-2013, 01:35 PM Go to last post
  4. Reverb tank hum help please :)

    Started by jimboyogi, 09-29-2013 03:18 AM
    • Replies: 28
    • Views: 2,815
    12-12-2013, 03:20 AM Go to last post
  5. phase inverter has too much gain

    Started by JoeK, 12-02-2013 09:59 AM
    • Replies: 10
    • Views: 2,509
    12-03-2013, 02:59 AM Go to last post
  6. New 5F2A, not sure voltages are good.

    Started by spsimmons, 11-03-2013 06:14 PM
    • Replies: 13
    • Views: 2,203
    11-15-2013, 05:13 AM Go to last post
  7. 5F11 voltage/amps issue...not able to bias

    Started by ron vogel, 10-24-2013 02:35 PM
    • Replies: 13
    • Views: 1,401
    10-28-2013, 04:15 PM Go to last post
  8. Biasing ?

    Started by chuckb, 10-23-2013 11:21 PM
    • Replies: 1
    • Views: 819
    10-24-2013, 03:09 AM Go to last post
  9. dropping resistors not dropping

    Started by cooldude666, 10-23-2013 11:33 PM
    • Replies: 4
    • Views: 872
    10-24-2013, 01:48 AM Go to last post
  10. 5F1 New Build Very Low Volume

    Started by bob78h, 09-27-2013 11:45 PM
    • Replies: 11
    • Views: 1,672
    09-28-2013, 10:19 PM Go to last post
  11. Might be a dumb Q

    Started by ldervish, 09-26-2013 04:36 PM
    • Replies: 5
    • Views: 1,009
    09-27-2013, 04:05 AM Go to last post
  12. Trem switching weirdness HELP PLEASE

    Started by jimboyogi, 09-24-2013 01:38 AM
    • Replies: 8
    • Views: 939
    09-25-2013, 02:37 AM Go to last post
  13. Exclamation Idle current going way too high

    Started by jussi, 09-07-2013 04:58 PM
    6v6
    • Replies: 7
    • Views: 1,412
    g1
    09-08-2013, 01:55 AM Go to last post
  14. Question Heaters blow fuse

    Started by jussi, 09-06-2013 03:52 PM
    6.3v
    • Replies: 5
    • Views: 1,079
    09-07-2013, 01:30 PM Go to last post
  15. 6G2 uneven bias wiggle

    Started by hylaphone, 09-02-2013 04:05 PM
    • Replies: 5
    • Views: 1,861
    09-04-2013, 04:07 AM Go to last post
  16. Ampeg B15 Build -- Bias supply question

    Started by hylaphone, 08-29-2013 12:16 AM
    • Replies: 22
    • Views: 2,375
    08-31-2013, 01:24 AM Go to last post
    • Replies: 2
    • Views: 843
    08-22-2013, 12:37 AM Go to last post
  17. Bad squealing in OR120 build.

    Started by antieatingactivist, 08-19-2013 04:37 AM
    • Replies: 9
    • Views: 1,297
    08-20-2013, 11:21 PM Go to last post
  18. New build with a baffling problem

    Started by ldervish, 08-11-2013 11:20 PM
    • Replies: 10
    • Views: 1,445
    08-20-2013, 02:31 AM Go to last post
  19. Please help. Troubleshoot first build?!?!?

    Started by hesamadman, 08-05-2013 06:01 PM
    • Replies: 17
    • Views: 1,352
    08-06-2013, 12:44 AM Go to last post
  20. Help with first build. 5F1 Champ

    Started by astark117, 11-18-2012 01:14 AM
    • Replies: 20
    • Views: 1,904
    07-19-2013, 11:35 PM Go to last post
    • Replies: 9
    • Views: 2,973
    07-02-2013, 02:23 PM Go to last post
    • Replies: 7
    • Views: 1,242
    06-19-2013, 07:10 PM Go to last post
  21. JTM 45 build

    Started by MikeT, 05-30-2013 04:23 PM
    • Replies: 5
    • Views: 1,389
    05-31-2013, 07:27 PM Go to last post
  22. Clone of a Clone

    Started by eric02, 05-26-2013 07:10 PM
    • Replies: 5
    • Views: 1,209
    05-29-2013, 05:10 PM Go to last post
  23. So they sent me E88CCs ?

    Started by gtrplayr1976, 05-21-2013 03:55 PM
    • Replies: 19
    • Views: 1,294
    05-23-2013, 01:51 PM Go to last post
  24. Crackles/pops in JCM800 build

    Started by bobshbob1, 02-12-2013 08:10 AM
    • Replies: 1
    • Views: 1,088
    05-20-2013, 04:55 PM Go to last post

Page 4 of 19 FirstFirst 1234567891014 ... LastLast

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •