Looking for the pot pcb (or pics/layout) from a Rotovibe

[danielzink]

I got this Rotovibe cheap in a parts lot.

It's missing the pot/switch/leds and board.

I'm wondering if anyone has one of these laying around that they could take some pics of (front and back of pot pcb) so I could fab something up and at least see if the pedal fires up.

Thanks !

[J M Fahey]

Not in the flesh but found this:

Apparently just the pot and a switch so if you get the circuit schematic somewhere, in principle you can add missing parts (still unmounted) and test it for functionality.

IF it works (hope so ), making the simple PCB or even using a piece of perfboard will restore it in full.

[danielzink]

Not in the flesh but found this:

Apparently just the pot and a switch so if you get the circuit schematic somewhere, in principle you can add missing parts (still unmounted) and test it for functionality.

IF it works (hope so ), making the simple PCB or even using a piece of perfboard will restore it in full.

That was my idea - to perf it up then etch a pcb.

I have that exact picture as well....unfortunately it doesn't show the pot connections...nor the switch connections...

[Enzo]

Or even no board. A zillion wah pedals are out there with the stomp switch and pot just wired to a connector for the main board, or even wired direct.

Did you CALL Dunlop and ask for a schematic or other notes? Have your serial number handy, sometimes it tells version.

[52 Bill]

I have one of those pedals somewhere. If you are not in a hurry, I'll look to see if it is the same model that you have. If it is, I'll post a few photos if you still need them.

[52 Bill]

I have one of those pedals somewhere. If you are not in a hurry, I'll look to see if it is the same model that you have. If it is, I'll post a few photos if you still need them.

I did find mine and it is the same version that you have, not the one in Juan's photo. The board says rev. B. If you still need the photos, let me know and I'll try and post them.