Tweet
Hi everyone,I want to start a new build.I have a bogen chb100 chassis,and transformers.I am thinking of a 50 watt plxi clone,with master volume.The 18 watt(20 w/diode rec)looks intriguing.I am afraid the 50 watt may be to loud to get a good sound.I have played blackface,and allways felt that it was to muddy for my tastes.I like the jtm45 clean tones.I play blues,rock,church on sundays,and occaisional club gigs.So I need some power for gigs,but I guess I could run it through the pa.
The plexi clone looks relatively uncomplicated,and wont cost to much in parts and tubes.If I put a master volume on it I should be able to get some tone.
Now the build,should I buy a board or can I use terminal strips without too much hassle.The chb100 chassis is large for what I want to do.So room is'nt a problem.I have the heater wires intact,so I would just have to chnge sockets,run components to the strips,or should I do it right,and buy/biuld a board?
Any comments would be appreciated,Clay
The plexi clone looks relatively uncomplicated,and wont cost to much in parts and tubes.If I put a master volume on it I should be able to get some tone.
Now the build,should I buy a board or can I use terminal strips without too much hassle.The chb100 chassis is large for what I want to do.So room is'nt a problem.I have the heater wires intact,so I would just have to chnge sockets,run components to the strips,or should I do it right,and buy/biuld a board?
Any comments would be appreciated,Clay
Comment