Hi again!
I am planning on using a 1 meg audio push/pull volume switch (I wanted to use the tone control but the volume is closer to the cap locations on my board) to switch 2 capacitors next to the 1st cathode resistor on my 5F2-A project for some tonal differences. The two values I have decided to use are 10uf and .15uf along with the 1.5K resistor. I am trying to keep wiring tidy, short and thought out for a change! My question to you fine folks is should I just use my 20g solid copper for the wire runs to the switch or a few pieces of my leftover RG174? The length from the volume switch to the 2 caps is about 4.5-5 inches and about 6.5 inches if I do dare try to run all the way to the tone control.
Happy Sunday all,
Dale
I am planning on using a 1 meg audio push/pull volume switch (I wanted to use the tone control but the volume is closer to the cap locations on my board) to switch 2 capacitors next to the 1st cathode resistor on my 5F2-A project for some tonal differences. The two values I have decided to use are 10uf and .15uf along with the 1.5K resistor. I am trying to keep wiring tidy, short and thought out for a change! My question to you fine folks is should I just use my 20g solid copper for the wire runs to the switch or a few pieces of my leftover RG174? The length from the volume switch to the 2 caps is about 4.5-5 inches and about 6.5 inches if I do dare try to run all the way to the tone control.
Happy Sunday all,
Dale
Comment