|
12-05-2008, 08:14 PM
| #1 |
| Junior Member  Join Date: Dec 2008
Posts: 1
| 
I've recently installed a buckethead-esque killswitch in my schecter hellraiser. I put the killswitch in where the tone pot used to be and left the tone pot floating in the cavity for the time being. My question is, can i take one of the volume pots out altogether, and solder both of the signal wires coming from the pickups to the other volume pot making it a master volume? This way I'll be albe to put the tone pot where the un-used volume used to be.... The stock wiring diagram can be found here http://www.schecterguitars.com/schem...nd%20C-1FR.pdf Any help is appreciated, cheers. Last edited by tboy; 12-06-2008 at 02:37 AM. |
|  |
| ...and now, a word from our sponsor: |
| |
|
12-08-2008, 09:12 PM
| #2 |
| Junior Member Join Date: Aug 2008 Location: Rochester
Posts: 8
|
You can do it-- EMG provides a diagram on their website. There's no killswitch on this one but I'm sure you can figure it out if you did it with the old config  http://www.emgpickups.com/downloads/.../EMG-ZWset.pdf Look for Diagram 3... it's sorta near the bottom of the page. |
|
| |
 |
| Bookmarks |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| speaker wiring question | Ebtronics | Maintenance, Troubleshooting & Repair | 3 | 10-30-2009 05:22 AM |
| Wiring Question!!! | lordnikon | Pickup Makers | 4 | 11-24-2008 05:29 PM |
| Megaswitch Question for HH Wiring | mikeboone | Guitar Tech | 3 | 07-29-2008 05:44 AM |
| Question about heater wiring in a Champ build | Regis | Theory & Design | 2 | 02-28-2007 12:47 AM |
Linear Mode
