Fine tuning strat single coil pups with a dummy coil?

Silent Bob · 11-04-2007, 06:15 AM

I'd like to start experimenting with dummy coils in a Tokai strat which I'll be reassembling soon. I'm thinking of making a triangularish bobbin shaped to fit into the bottom of the control cavity as the dummy.

Being so small I doubt it will work as well as the Suhr backplate system but I'd like to give it a go.

Can anybody provide a schematic of the Suhr Adjusting PCB? I've had a look at the patent and the install manual, but some of the component values are missing and I can't quite conceptualise it yet.

Anybody seen one of these PCBs up close?

11-04-2007, 06:15 AM	#1
Silent Bob Junior Member Join Date: May 2006 Posts: 5	Fine tuning strat single coil pups with a dummy coil? I'd like to start experimenting with dummy coils in a Tokai strat which I'll be reassembling soon. I'm thinking of making a triangularish bobbin shaped to fit into the bottom of the control cavity as the dummy. Being so small I doubt it will work as well as the Suhr backplate system but I'd like to give it a go. Can anybody provide a schematic of the Suhr Adjusting PCB? I've had a look at the patent and the install manual, but some of the component values are missing and I can't quite conceptualise it yet. Anybody seen one of these PCBs up close?

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
low z single coil and 60 cycle	Rosewood	Pickup Makers	6	10-25-2007 01:56 PM
Coil tapped single	Spence	Pickup Makers	11	08-29-2007 01:04 AM
Dummy coil question	truetone	Pickup Makers	19	04-30-2007 08:27 PM
single coil magnets in a HB?	franklin01	Pickup Makers	8	09-24-2006 01:41 AM
suhr and dummy coil...	swt	Pickup Makers	23	09-08-2006 05:44 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)