Dr. Z 6545 Presence Control

benttop · 06-03-2006, 04:48 PM

I would like to add some means of dialing in some presence on this amp. Before I spend a pile of time reverse engineering the schematic, has anyone already done such? Any advice about the best way to go about adding a presence control to this amp? Any help is appreciated.

jaydawg · 06-05-2006, 06:20 PM

as far as I know, the presence control is a variable feedback look. So just add a NFB and use a pot in place of the resistor.

benttop · 06-05-2006, 08:42 PM

Quote:

Originally Posted by jaydawg

as far as I know, the presence control is a variable feedback look. So just add a NFB and use a pot in place of the resistor.

I'll have a look at that. Not sure if there is NFB already on that amp or not (probably is). A good place to try some experiments I suppose - still have to reverse engineer the schematic from the chassis...

06-03-2006, 04:48 PM	#1
benttop Junior Member Join Date: Jun 2006 Location: Renton, WA Posts: 2	Dr. Z 6545 Presence Control I would like to add some means of dialing in some presence on this amp. Before I spend a pile of time reverse engineering the schematic, has anyone already done such? Any advice about the best way to go about adding a presence control to this amp? Any help is appreciated.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

06-05-2006, 06:20 PM	#2
jaydawg Member Join Date: Jun 2006 Location: York, ME Posts: 37	as far as I know, the presence control is a variable feedback look. So just add a NFB and use a pot in place of the resistor.

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)