Building a Princeton Reverb and ran into an issue. I am using an "updated" Output transformer that has 4, 8, and 16 ohm taps. The original PR only had an 8 ohm output. Looking at the circuit (link below) you can see that the output (both the internal and external jacks) run back through as the negative feedback to V3B.
If I am using a multi-tap output, how would I wire the NFB? I really do not want to use an output impedance selector switch (want to have a jack for each output impedance) so... how can I get around this? Or... can I???
*** using the AA1164 version ***
If I am using a multi-tap output, how would I wire the NFB? I really do not want to use an output impedance selector switch (want to have a jack for each output impedance) so... how can I get around this? Or... can I???
*** using the AA1164 version ***
Comment