V4-B ground scheme

[trem]

As far as grounding the caps, and a ground scheme in general, what is the "best" way for me to approach this V4-B.? I replaced the E-Caps and tried to clean up some other "mods". The vertical terminal strip next to the Series/Parallel can cap connection was put in by me. It may be a little hard to see, it is caught in the flash at the TWO can caps. I can take it out if you guys think it is problematic. But there was a lot of connections to be made in that area, and this made things easier for me. This is a wide chassis and the caps are spread out across the whole chassis.
The hum balance pot was bad. I have never used those on an amp before, so I went with the 2x100 ohm resistor heater CT. I have them hanging off the first power tube, and terminated at the mains ground.
Thank You


Image hosting, free photo sharing & video sharing at Photobucket
Image hosting, free photo sharing & video sharing at Photobucket
Image hosting, free photo sharing & video sharing at Photobucket
Image hosting, free photo sharing & video sharing at Photobucket
Image hosting, free photo sharing & video sharing at Photobucket
Image hosting, free photo sharing & video sharing at Photobucket
Image hosting, free photo sharing & video sharing at Photobucket
Image hosting, free photo sharing & video sharing at Photobucket
Image hosting, free photo sharing & video sharing at Photobucket

--------------------------------------------------------------------------------
Last edited by