Tweet
Ok i want to make a clone of the John east 5 knob deluxe pre amp and EQ for my bass. But i'm a bit stuck on coming up with a schematic for it. and working out value of components to use to give me the desired EQ setup as shown in the specs.
There are a few mods that i want to make to it.
Rather than a push/pull passive/active tone pot. i want the tone pot just to be a standard pot and use a DPDT switch for the passive/active switch.
i dont want the bright control on the treble knob, this can just be a stacked bass and treble knob.
I'm planning on going for a TLE2702 op amp. From the pictures it looks like there is 3 IC circuits. Would these all be op amps?
Any help would be greatly appreciated.
There are a few mods that i want to make to it.
Rather than a push/pull passive/active tone pot. i want the tone pot just to be a standard pot and use a DPDT switch for the passive/active switch.
i dont want the bright control on the treble knob, this can just be a stacked bass and treble knob.
I'm planning on going for a TLE2702 op amp. From the pictures it looks like there is 3 IC circuits. Would these all be op amps?
Any help would be greatly appreciated.