Where do these wires go?

[iamblkrain]

Hello all. I have recently purchased an Epiphone Les Paul Standard body/neck only. I then purchased an electronic set up out of an Epiphone LP-100 to put in the guitar as well as 2 Epiphone used gold humbuckers. I have 2 questions that I hope you all can help me with. 1. The lead wire that goes to the 3 position switch from the bridge volumn pot has the ground shielding as well as 2 wires going to the 3 way switch 1 is red and 1 is white. How do I wire these 2 leads to the switch? 2nd question, The bridge humbucker is a 4 wire blue, black, red and white. The red and white wire have been twisted together. I have read about a number of 4 wire schematics that say to solder together 2 of the wires but none of them have been red and white. Is this correct for an Epiphone pickup? All I could ever find diagrams were for Dimarzio, Seymour Duncan etc. I could never find Epiphone diagrams.

Thank you in advance for any help.
Chuck

[SpareRibs]

Guitar wiring

Hello,
I have no doubt someone here could answer your question, however someone over at the Les Paul Forumm would be able to answer that question in short order. I am curious as to whether Epiphone even has a web site to find information about things such as that. I have several of their guitars and information is hard to come by

[Flotingerth]

Hey, if you haven't already found this then here is a treasure trove of info
2 Pickup Guitar Diagrams

OK, late news try this too!
http://www.gibson.com/en-us/Support/...ng%20Diagrams/