Announcement

Collapse
No announcement yet.

Bridge on 18v neck on 9v is this good schematic

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Mick Bailey
    replied
    The opamp is different to a regular device in that it is programmable using a single resistor - presumably R8 in the schematic. According to the spec sheet "A single external master bias current setting resistor programs the input bias current, input offset current, quiescent power consumption, slew rate, input noise, and the gain-bandwidth product". The resistor is selected based on the positive supply voltage, which for this opamp is +/-1v to +/-18V. So no issues with the supply voltage being 9v or 18v, but there would be changes to the operating parameters which could only be established from the spec sheet.

    Other than that the proposed circuit looks fine to me.

    Leave a comment:


  • eschertron
    replied
    That's interesting. I suspected that you were looking for a little less gain out of the neck pickup, never thought that it would affect the tone. But yes, go for it!

    Leave a comment:


  • Emetal
    replied
    Originally posted by g1 View Post
    It appears to me that it should work ok as there are caps blocking any DC.
    But my question would be, why not run everything on 18V? Can the 85 not handle it?
    EMG 85 looses highs, it sounds dull, to my ears at least, when run on 18V. I simply do not like it. It sounds good on 9V.

    Leave a comment:


  • g1
    replied
    It appears to me that it should work ok as there are caps blocking any DC.
    But my question would be, why not run everything on 18V? Can the 85 not handle it?

    Leave a comment:


  • Emetal
    replied
    eschertron Here is EMG schematic, does it still look OK :-)
    Last edited by Emetal; 08-20-2020, 07:13 PM.

    Leave a comment:


  • eschertron
    replied
    Without knowing anything about the internal workings of the EMG pickups, I'd assume that the signal wire going to the three way switch is isolated from the power supply wire. The signals are simply signals regardless of the voltage running the amps, and since there's no coupling caps elsewhere in the circuit they must be upstream of the signal leaving the pickup (that's the basis of my assumption). If that's correct, no problem with the voltage boost for the bridge pickup.

    Disclaimer: I am not responsible for any 'magic smoke' leaving the pickups

    Leave a comment:


  • Emetal
    started a topic Bridge on 18v neck on 9v is this good schematic

    Bridge on 18v neck on 9v is this good schematic

    Hi everybody, I would like my EMG 81 in the bridge to run on 18 volts and my EMG 85 in the neck on 9 volts. I am attaching photo of a default connection and a second photo of the mod I am wondering will it work? Opinions please, will this work? And even if both work individually, when switch in middle position will they both maintain their own voltages?
antalya escort
pendik escort
sex vidio
porno
antalya escort
beylikduzu eskort bayan eskort bayan escort antalya sirinevler bayan escort
gaziantep escort
Working...
X