Hi PALEEMAN.
I need service manual or schematics of dynacord powermate 3 series
Thanks 🙏
Announcement
Collapse
No announcement yet.
dynacord amps 600/1000/1600 repair help.
Collapse
X
-
Hi guys i have a power mate 1000-3 and i need the hex file for programing atmega48 in smps section. Anyone can help plz?
Leave a comment:
-
-
Wrong number provided
Originally posted by Jazz P Bass View PostHere you go: [ATTACH]45842[/ATTACH]
Many thanks for your help, really appreciated.
I wrote the wrong part number
the correct model is PowerMate 1600-3, its shown already in post #5
Here https://factorysound.com/products/pm1600
Please help me with that schematicLast edited by Mikale; 11-23-2017, 09:00 PM.
Leave a comment:
-
Dynacord cms1600-3
Hello
I am looking for the service manual for the Dynacord CMS1600-3.
I have one units with no audio output at all from the pre amplifier stage.
Any help is more than appreciated
Regards
Leave a comment:
-
Guys.. i encounter another strange problem with two Dynacords the other day..PM600 and PM1600. both are old AB amps with transformer power supply.
The problem is.. these dynacords will switch on normally if i use 110v power supply or even if i use a 60w series bulb with 220v supply ( i alwsys use series bulb power supply to check repaired amps) . but it i plug directly into 220v supply, the protect light will turn on and fan spins at highest speed (the same behaviour when any or both channels are burned) . and the relays ( both speaker relays and power relays continue to click repeatedly insted of staying on or off.. but after a while.. like 2-3 minutes, it just turns on.. and amp works properly. ( seems like some component needs to heat up and then it functions properly ... lol am i missing some vaccum tube in the circuit!) .
Btw, there is no short-circuit with any of the channels, nor any transistor on power amp section is burned ( because it just works fine once when it is turned on) . I checked the same with disconnecting dc dual supply lines to power amp section , for synacords use seperate power lines to power amp section and another power line for all contols, fans, preams, effects board, relays etc.. and then too the same problem happens.. so i belive it has nothing to do with power amp section.
every volatage diagnosis pins shows the correct volatges. with in .5 - 1v difference at maximum. i changed the 074 opamp which controls the temp and fan speed, but no use.
what would be a possible reason for this strange behaviour..?? btw . both amps use 220v transformers.
i cant even figure out ,why it works normally with a low voltage supply, but shows faults with the normal supply.
i have checked all Transistors and diodes with the delay and relay driver sections.. all are ok.. not even a single weak Transistor.
This is soo strange.. if some one had figured out similar problem , please share it.. its been a real headache for me for past few days.
Leave a comment:
-
sorted out all analog dynacords.. thanks for your help.
now i need one more help. does anybody have dynacord powermate 600- v3 ( latest digital model with smps power supply) circuit diagram?
it got the chip damaged ( second picture) , i have replaced that ,along with a burned resistor and lm317 regulator ic, but its still not powering on.
so if any one have that circuit diagram, please share, so that i can find out the related components.
Leave a comment:
Leave a comment: