Tweet
I have built a simple footswitch to control the channel change, delay and chorus on this amp, i.e. 3 non-latching switches in one enclosure. Can anyone provide me with a schematic showing how to add LED's to these three switches?
-
-
The Roland Cube 60 schematic I have doesn't have a chorus, and the footswitches would have to be latching types unless you wanted to stand on the thing. Perhaps you can link us to a schematic for yours.
In any case, if your's is controlled by momentary switches, then the only way to add LEDs would be to tap into the circuits in the amp and run extra wires down to the pedal. Or alternatively design a latching logic circuit for the pedal itself, but that wouldn;t guarantee matching the amp status.Education is what you're left with after you have forgotten what you have learned. -
Hi I can email you service notes for the cube 60 if you send an email address to spares@roland.co.uk
very best regards
steve (Roland UK spares dept)Comment
Comment