Search:

Type: Posts; User: jjj; Keyword(s):

Page 1 of 7 1 2 3 4

Search: Search took 0.02 seconds.

  1. Replies
    33
    Views
    2,045

    The last 4 days it was raining non-stop here in...

    The last 4 days it was raining non-stop here in Townsville Qld.4814 and that gave me a chance to investigate the problem further.
    Result: After I disconnected the ETI Howlround (which I built) the...
  2. Replies
    33
    Views
    2,045

    Yes, it could be that the 100W needs a stronger...

    Yes, it could be that the 100W needs a stronger input signal. That's why it acts so weird with a weak signal. In that case I would need to amplify the strengthen the reverb signal. The Chinese sell...
  3. Replies
    33
    Views
    2,045

    Yes, the Sony Amp runs on the same 11.1V LiPo...

    Yes, the Sony Amp runs on the same 11.1V LiPo battery as well. It could be that the 100W Class D Amp. needs a stronger signal. In that case I would need to amplify the strengthen the reverb signal....
  4. Replies
    33
    Views
    2,045

    Test result: If I ran the same setup with my Sony...

    Test result: If I ran the same setup with my Sony car Amp and I haven't' got this problem. Yet, since I tried to create a small traveler's unit with the same components I ran into 1000 problems. To...
  5. Replies
    33
    Views
    2,045

    My victory celebration came too early... I just...

    My victory celebration came too early...
    I just finished to add that (shown) voltage up circuit and adjusted it to 22V. It all looks good, but.. but when switch the system on the full sound volume...
  6. Replies
    33
    Views
    2,045

    I have no doubt that you are all experts in...

    I have no doubt that you are all experts in electronics and that's why I begged you for help. Enzo helped me in the past and I never forgot him, too. :)
    I read all the posts and at the same time...
  7. Replies
    33
    Views
    2,045

    The model is: "China garbo"/ Chip: TPA3116 D2...

    The model is: "China garbo"/ Chip: TPA3116 D2
    Yes, you are right... if I turn it off and wait for about 10 seconds and then turn it on, the volume doesn't jump high and then slowly lowers, but the...
  8. Replies
    33
    Views
    2,045

    I built a busking Amp for the demonstration of my...

    I built a busking Amp for the demonstration of my whistling to good music. It consists of:
    1) electret Mic PreAmp,
    2) ETI-486 Howl-round Stabilizer,
    3) Pedal Reverb and a
    4) 100W (class D) Amp...
  9. Replies
    33
    Views
    2,045

    Well, it sounds like everything in my little PA...

    Well, it sounds like everything in my little PA is bad, but I don't think it's really ...that bad. Today I changed the Mic PreAmp for a China made one and it sounds as good as my old two transistor...
  10. Replies
    33
    Views
    2,045

    Thx for the helpful reply. I just now monitored...

    Thx for the helpful reply. I just now monitored the battery on turn on etc: it showed a steady 12.56V !! The speaker is a "Pioneer" 8 Ohm speaker model.

    I swapped my old two transistor electret...
  11. Replies
    33
    Views
    2,045

    ===================== Soy de origen aleman....

    =====================
    Soy de origen aleman. Egualmente, tu ingles es incredible... por un gaucho de la Pampa. :) - Una senorita ofrece a un caballero un mate y el caballero contesta: "Un mate...
  12. Replies
    33
    Views
    2,045

    Ola amigo... estuve 15 anos en St'go de Chile y...

    Ola amigo... estuve 15 anos en St'go de Chile y ahora habla un poquito chileno. (Una broma para ti: "Mi amigo que fue catholico se puso lutherano, porque le gusta el utero y ano!" :)
  13. Replies
    33
    Views
    2,045

    That's the Amp...

    That's the Amp...
  14. Replies
    33
    Views
    2,045

    Weird audio Amp problem...

    I built a busking Amp for the demonstration of my whistling to good music. It consists of:
    1) electret Mic PreAmp,
    2) ETI-486 Howl-round Stabilizer,
    3) Pedal Reverb and a
    4) 100W (class D) Amp...
  15. Now, since I successfully MIDI-fied an old...

    Now, since I successfully MIDI-fied an old 120-button accordion bass (bass section only), I thought of adding a 6-row Janko adapter and place it over my Tyros 3 keyboard. I then can play it like a...
  16. Thank you nickb for that kick! - Yes, that would...

    Thank you nickb for that kick! - Yes, that would be another trigger angle to consider, provided it fits onto a finger ring and it would need transmit its trigger signal to a stationary unit, which I...
  17. Yes, its that lousy little bulb-like switch! ...

    Yes, its that lousy little bulb-like switch!
    Yet as mentioned, I'll be better off triggering the Tyros's after-touch. I.e. disconnecting and changing it for a more sensitive after-touch tape,...
  18. The mercury switch is very small and mounted on a...

    The mercury switch is very small and mounted on a finger ring it could be shaken (like the "Hot Hand" gadget) and so, triggering either a filament bulb shining onto an LDR for volume variations.
    As...
  19. Greetings Mick Bailey, The Tyros's pressure...

    Greetings Mick Bailey,
    The Tyros's pressure sensor tape (of after-touch) is a bit hard to activate. I adjusted it to "light", but it's still far to hard to activate don't use it.
    I could...
  20. Hi Enzo, you good rescue angel! You have a lot...

    Hi Enzo, you good rescue angel! You have a lot electronics knowledge and that's the thing I admire, but personally lack. All I can do is to search for circuits, which might deliver the goods I'm...
  21. Emulating accordion bellow shake for Synth keyboards...

    My Tyros got nice accordion sounds, but I wished I could somehow add that missing bellow shake. I was thinking that might somehow be possible? So, far my limited electronics knowledge led me to...
  22. Replies
    58
    Views
    7,643

    Yes... I too prefer peace and quality of life,...

    Yes... I too prefer peace and quality of life, but that's only possible to enjoy if one takes all the necessary precautions. - For instance, here in St'go de Chile I need to be checking out the...
  23. Replies
    58
    Views
    7,643

    Well, the only alternative then is to move away...

    Well, the only alternative then is to move away from dangerous areas or facing the legal consequences.
    Thus, if you prefer to stay in this dangerous area be prepared and for me it is to electrify...
  24. Replies
    58
    Views
    7,643

    Yes, I know... helping me to keep out of trouble,...

    Yes, I know... helping me to keep out of trouble, can also mean helping gangsters gaining easier access and the result will be that I (not the gangster) will be the loser. Thus, my preferred choice...
  25. Replies
    58
    Views
    7,643

    Looks very neat! Yea, I think anyone climbing in...

    Looks very neat! Yea, I think anyone climbing in our property deserves to whatever he gets... and we ask the questions later. Better that, than being robbed, attacked or murdered by some mentally...
  26. Thread: Car immobilizer

    by jjj
    Replies
    13
    Views
    2,016

    Thank you J M Fahey, Chile's carabineros are...

    Thank you J M Fahey,

    Chile's carabineros are doing a great job in catching criminal, but the lousy justice system puts them back into the streets... Their excuse is: we don't have enough jails!...
  27. Thread: Car immobilizer

    by jjj
    Replies
    13
    Views
    2,016

    If you get hijacked at pistol point, you won't be...

    If you get hijacked at pistol point, you won't be thinking of trying to look for the solenoid cutoff switch... that's why I want to keep it "lo profile" to get them some 100 yards away from me and...
  28. Thread: Car immobilizer

    by jjj
    Replies
    13
    Views
    2,016

    Futile, for these stupid youngsters will torture...

    Futile, for these stupid youngsters will torture me to get me to enter the correct code... Its smarter to keep "lo profile" to get them some 100 yards away from me and having engine start problems...
Results 1 to 28 of 195
Page 1 of 7 1 2 3 4