Search:

Type: Posts; User: shortcircuit; Keyword(s):

Page 1 of 10 1 2 3 4

Search: Search took 0.02 seconds.

  1. Replies
    14
    Views
    231

    Thanks for the info G1 , because of where this is...

    Thanks for the info G1 , because of where this is on the board, I'll opt for the Corona.
  2. Replies
    14
    Views
    231

    Yes critical area , that's why I'm looking for a...

    Yes critical area , that's why I'm looking for a sealer, but I only need a fingernail polish bottle not a quart /and have found but shipping:mad:. V5 El84 tested great (Russian Groove tube) , socket...
  3. Replies
    14
    Views
    231

    Do you use any sealer of any kind after ?? I see...

    Do you use any sealer of any kind after ?? I see nevetslab mention the Corona
  4. Replies
    14
    Views
    231

    Thanks Dude , I was going to ask what others...

    Thanks Dude , I was going to ask what others would do to deactivate the remains:thumbsup:
  5. Replies
    14
    Views
    231

    Thank You nevetslab !!!!

    Thank You nevetslab !!!!
  6. Replies
    14
    Views
    231

    Blues Junior trace be gone

    I just got this in , no sound , powers up , all tubes are lit , slight hum from the speaker . First suspect the cheesy input jack , get access to the back of the board surprise:surprised: trace taken...
  7. Sounds like you have your foot in the door with...

    Sounds like you have your foot in the door with them with previous business , contact them and explain what you want, and what you were disappointed with before . A place to start :thumbsup:
  8. You will not regret building a limiter , .....

    You will not regret building a limiter , .. don't mix your Bb with an A#:)
  9. Replies
    18
    Views
    338

    ^^^^^ so much for a Pete Townshend endorsement:D

    ^^^^^ so much for a Pete Townshend endorsement:D
  10. Replies
    18
    Views
    338

    RELISH guitar

    Thought this looked interesting enough to share.


    https://www.youtube.com/watch?v=M_fqLR0dRTw
  11. Replies
    27
    Views
    900

    Haven't seen any mention of the spring and claw...

    Haven't seen any mention of the spring and claw set up, if you check out live photo's of SRV, Jimi, VH ,JB, take note of the spring arrangement and how tight they have the claw screwed in . As...
  12. ^^^^^same schematic I referenced post #8 from,...

    ^^^^^same schematic I referenced post #8 from, all apologies for not posting then.
  13. The odds are stacked against you,especially after...

    The odds are stacked against you,especially after 9+ yrs, again if you can give them a shake, may save time and effort. Good luck !!
  14. Do the batteries have any voltage in them ?? If...

    Do the batteries have any voltage in them ?? If you can get to them,disconnected,give them a shake , if you hear any rattle like grains of sand , they are sulfated and are junk. The only schematic I...
  15. That does answer a question I had, after doing...

    That does answer a question I had, after doing the no no:surprised: (assuming) they were SLA batteries. I'm thinking the 15v designation is Pignose way of getting you to buy their adapter. it does...
  16. The example is from my car's jump pack , intended...

    The example is from my car's jump pack , intended for charging , and I think would work for your situation. I do agree it's a different circumstance when it's an specific operating adapter such as a...
  17. If your wall wart is only putting out 12.4v I'd...

    If your wall wart is only putting out 12.4v I'd suspect a bad wall wart, most 12v adapters put out any where from 13.5 and above.Grabbed the first one in front of me.
    5381353814
  18. Replies
    51
    Views
    2,110

    I finally got back to these , I put this into a...

    I finally got back to these , I put this into a build , I can remove the battery with no change , shouldn't that cancel out the piezo ?? So I simplified a bit put this into a build( the crappy hand...
  19. I dropped a line to Floyd Rose , Do you have any...

    I dropped a line to Floyd Rose , Do you have any locking nut ,that would replace a Jackson
    JT-6 without major modification??
    here is the reply
    "The nut you will need for your Jackson is the R3....
  20. Replies
    40
    Views
    1,495

    Does it pass a clean signal without the 3v supply...

    Does it pass a clean signal without the 3v supply ??
  21. Stamped Jackson , Lisc. Floyd Rose, I believe ....

    Stamped Jackson , Lisc. Floyd Rose, I believe . One on Ebay, just ended on the 11th, might be worth looking into...
  22. Have to ask the obvious , have you tried...

    Have to ask the obvious , have you tried contacting Fender/Charvel ?? Jackson ?? Can you give us a pic ?? Was it made by Kahler ?? or Floyd Rose ?? With all the locking trems out there, I'm...
  23. Replies
    40
    Views
    1,495

    And double check your transistor orientation as...

    And double check your transistor orientation as far as 1,2,3,Small Bear usually gives you the hfe and placement . Just a thought.
  24. 5349553496

    5349553496
  25. Replies
    51
    Views
    2,110

    aaand no we're not , have since put a pre amp in...

    aaand no we're not , have since put a pre amp in plan one build as well , lesson learned, all is good. :thumbsup:
    And now I'm off to a noisy Vox Cambridge 30 twin , one with the supposed 60watt mod...
  26. Replies
    51
    Views
    2,110

    Update : plan #1 is leaving the Alumitone set up...

    Update : plan #1 is leaving the Alumitone set up as is , piezo to a 10k pot both sent to a TRS stereo out jack , stereo Y cable out, send the piezo through a pre-amp(tech 21 is on the way) to one amp...
  27. Replies
    6
    Views
    431

    my apologies , glad alexradium was able to help,...

    my apologies , glad alexradium was able to help, good luck !!
  28. Replies
    6
    Views
    431

    53331

    53331
Results 1 to 28 of 261
Page 1 of 10 1 2 3 4