Announcement
Collapse
No announcement yet.
Search Result
Collapse
273 results in 0.0182 seconds.
Keywords
Members
Tags
-
Just checked DL- 92mbps UL- 37 mbps
-
Take a good look around. The amp gets really hot which translates into some decent temp swings on the board. I use really good light and two pairs of readers...
Leave a comment:
-
OK thats about spec at 400vdc. The bias is just tooo low from the factory. Had the same issue with my DC-3. Any tubes I tried (even low current draw) were...
Leave a comment:
-
Well at least they tried-and tried pretty hard unlike these "Brimars" which aren't Brimars -just rebranded as of yet. Anyhow I received multiple...
Leave a comment:
-
The JJ6V6 will handle and spec'd for 500pv. As long as you can bias them correctly and use use half of the previous impedance setting it should work fine....
Leave a comment:
-
Yeah as drewl mentioned they run them insanely hot. My DC-3 was 420VDC on the plates and only -11 as designed. No tubes would run less than 110%. The neg...
Leave a comment:
-
Thanks guys! Went right for the throat and soldered in a new transistor. Bingo! loop works fine now! Just have to pull it apart and solder it in properly...Last edited by rockon1; 02-20-2019, 11:18 PM.
Leave a comment:
-
I dont think people stopped buying Gibson. I think guitar sales are down overall and that combined with poor management trying to diversify put them in financial...
Leave a comment:
-
Did I miss something? They filed for chapter 11 but aren't belly up. Bob
Leave a comment:
-
Ordered a few transistors, caps and resistors. I'll report back when I know more. Thanks, Bob
Leave a comment:
-
Yes , my other VC50 is a few feet away. I just unplug it from the one I'm having trouble with into the other one and the cable/pedal works fine. Yes -if I...
Leave a comment:
-
I took the pedal and cable and plugged it into my other VC50 and it works fine- cable is plugged in correctly. The contacts close fine too since the amp works...Last edited by rockon1; 02-14-2019, 10:55 PM.
Leave a comment:
-
Crate VC50 FX loop trouble.
Recently fixed up an old VC50. Cleaned the pots, jacks and fixed it with a set of tubes that ran in good range. Cleaned it up, replaced the grill etc. Sitting...
-
I remember for a while brand new Sovtek 12AX7WA's would have a decidedly dark looking getter- not at all silvery like you would expect. Im just saying- use...
Leave a comment:
-
Ok I'll stand by that. Aiken is a very well respected amp builder. As time goes on however Ive seen a lot of crazy contradictory stuff too. My aforementioned...Last edited by rockon1; 02-03-2014, 08:40 PM.
Leave a comment:
-
Well Roger Crimm says crossover distortion is a good thing with the 5150. That's a first I've heard of it being a good thing. At any rate a set of tubes...
Leave a comment:
-
Ok read it but he doesn't really explain much about how much crossover distortion is "severe" or why it's a good thing for the 5150. He does go...Last edited by rockon1; 02-03-2014, 02:53 PM.
Leave a comment:
-
Agreed. The hat sits on 70% as the end of the line go no further not this is where it has to be imo. I'd like to see that article thiugh. 23% seems silly....
Leave a comment:
Leave a comment: