i finally got time to piece a little recording of the 5g9 modded with the reverb. i think it came out good and i slowed down the tremolo.
...
Announcement
Collapse
No announcement yet.
Search Result
Collapse
133 results in 0.0127 seconds.
Keywords
Members
Tags
-
i am trying to post the schematic image, hope it works. i ending up removing this mod. was not impressed. it kept me busy during the pause (covid19...
Leave a comment:
-
I am only grounded at the output speakers jack. although, i had been given the suggest to ground it back to the power node spot. did not know the theory...
Leave a comment:
-
GOT IT! No additional grounding wire needed.
Just wanted to make sure i was not inducing a parasitic grounding issue.
TYLast edited by Dandrix; 08-04-2020, 09:02 PM.
Leave a comment:
-
"The bottom side of the feedback network gets to ground by another means on the Tag Board."
So, no additional grounding needed?...
Leave a comment:
-
“connected is the bottom (0v side) of the 100 Ohms resistor of the 820 Ohm/100Ohm divider.”
so, that would be connecting a wire to...
Leave a comment:
-
Where would I ground output transformers to?
Would I wire this output transformer to the preamp ground? I am realizing that my setup as pictured is not grounded on my build (AB763). My second question...1 Photo
-
I have very little volume ( sounds like it’s on three). It’s wired according to the layout (pictured). I have very little experience with this...
Leave a comment:
-
I need help wiring a 1ma push-pull volume pot
Thanks for your help up front. I am modding my normal Channel clone amp (fender ab763). I have very little volume ( sounds like it’s on three). It’s...3 Photos
-
One input jack for ab763 clone
What resistor would i use if i wanted to omit the second input jack on my ab763 clone? there is usually two 68k ohm resistors (grid stoppers). some builds...
-
C supply is being used with the mod so, my bad. NO, extra filter cap supply available....
Leave a comment:
-
nope, it was an original ab763 circuit (super reverb kit). And you saw the mod i that i posted a couple weeks ago. (some marshall / vox bark). You remember...
Leave a comment:
-
Extra filter cap supply spot available
So, i have removed my tremolo circuit in my ab763 clone build, for a modded marshall circuit (some marshall / vox bark) in its spot. I have a filter supply...
-
That’s the fix. Input jack now grounded to pre amp ground. All pots hit ten now without cutting out.
The post from 2013 was another build I was working...
- Likes 1
Leave a comment:
-
I found the thread from 2013, sorry.
No, I have have not grounded the input jacks with shielded wire. I will do this, I really never turn my amp over...
Leave a comment:
-
Pdf64,
Would you please refresh my memory on the:
“The possibility was raised the your previous thread on a Mojo SR build of the issue being...
Leave a comment:
-
i have touched up solder joints on all vibrato pots and tone stack section. the volume pot would be my first choice for replacement?
Leave a comment:
-
-
Whats the cause of volume cut out?
What causes volume to cut out? i am testing my controls out on the vibrato side of my Super Reverb(ab763) and noticed that the volume turned up to nine and...
-
That’s the spirit I am looking for. Thanks Zouto
I guess, I was looking for an explanation of this Brit mod. It seemed to be a lot of work...
Leave a comment:
-
Yes to all, it’s super reverb kit from mojo. I don’t use the Trem. I thought it would worth modding seeing that I do not use normal channel? I was curious....
Leave a comment:
Leave a comment: