Announcement
Collapse
No announcement yet.
Search Result
Collapse
500 results in 0.2989 seconds.
Keywords
Members
Tags
-
Enjoy your retirement, Enzo! You have certainly earned it! Your contribution to the DIY community over the years has been huge and very much appreciated....
-
I found that raising the output impedance of a solid-state amp (irrespective of how it's done) gives better results with guitar speakers.
The...
Leave a comment:
-
You could try the Magnatec BUZ901P and BUZ906P, I believe they are just about identical.
Leave a comment:
-
Ten Pin Ninjas
The Ten Pin Ninjas' first album is out now, look for "Ten Pin Ninjas" on your favourite streaming and download services! For extra punk street...
-
The IRFP240/9240 can be used without flames, but it is not trivial, Rod Elliott explains how.
Using HEXFETs in High Fidelity Audio...
Leave a comment:
-
I second the call for some sort of wheel or leg system that would enable the amp to run away when it sees a guitarist with a soldering iron.
Leave a comment:
-
-
The transformer, rectifier etc. will certainly always get hotter with increasing output power. But above 40% output power the output transistors will start...Last edited by Steve Conner; 10-21-2013, 01:20 PM.
Leave a comment:
-
The whole point of the "E" series rectifiers is that the heater is well insulated from the cathode and can run off the same 6.3V winding as all...
Leave a comment:
-
It's important to remember that the maximum dissipation in a Class-AB amp isn't when it's putting out its maximum output voltage. As you turn it down below...
Leave a comment:
-
-
I like Reaper. You're supposed to buy a license for $60, but the free trial never expires, it just puts up a nag screen now and again. The plugins it ships...
Leave a comment:
-
You tried connecting the mics to your sound card via a capacitor. This is the right kind of idea, because capacitors pass high frequencies and block low ones....
Leave a comment:
-
The Unleash is just an attenuator with a line out, connected through a volume control to a solid-state power amp. The power amp happens to be Class-D but...
Leave a comment:
-
Well, how can you truly know the time if you don't understand how a watch works? And what better way to understand than building one?
Leave a comment:
-
Well, when you dump charge into a capacitor, the electric field aligns polarised molecules in the dielectric, storing more energy than if the dielectric were...
Leave a comment:
-
I think it's to allow you more flexibility in driving it. Each speaker is 8 ohms, so you can connect them in parallel for 4, or series for 16, or drive them...
Leave a comment:
Leave a comment: