Announcement
Collapse
No announcement yet.
Search Result
Collapse
500 results in 0.2180 seconds.
Keywords
Members
Tags
-
Thank you...I did finally manage to get registered at that site....I take it that you have repaired these before..if so I have a question....did you have...Last edited by bsco; 03-22-2024, 05:41 PM.
-
OK. I got it to finally work..I have no idea what the problem was....anyway it's all good now.....thanks......
Leave a comment:
-
I can't get signed up for some reason......it says the account is already in use but apparently not by me......I will try that site again just to see what...
Leave a comment:
-
Fostex Model 250 Service Manual
Good morning to everybody...hope everybody is doing good....I have this 4 track mixer/recorder for repair and was looking for a service manual....the problem...
-
-
Behringer Eurolive F1220A schematic
good afternoon..it has been awhile since i was here last....looking for a schematic for this unit....if possible......Thanking in advance .....
Che...
-
7025A tube replacement for a Ampeg B15S from 70's
Good morning....I have some 6L6GC tubes here with the same pin out as the 7025A..(pins 1 and 6 not used)....are these tubes safe to use in this application??...
-
-
Behringer PMP 4000 issues
Sorry about the previous post....it is a PMP4000 and not a PMP3000 flashing lights....no shorted components that I can find and nothing burned up.....trying...
-
Behringer PMP3000 schematics
Good day to you all.......I have this mixer that I am trying to repair for a friend of mine...the unit has flashing lights.......so looks as if the power...
-
@ Helmholtz. checked out my old analog meter....10k ohms/volt on the AC range and 30K ohms/volt on the DC range....so I will take your advice and use the...
Leave a comment:
-
I'll check my meter out later this evening and let you know.........thanks for the info...much appreciated.........
Leave a comment:
-
great info there.....so I have a question....what about an analog VOM?? they usually have a low impedance come to think of it......the digital meters are...
Leave a comment:
-
Actually, I never knew that...this is a great tip for sure.....and yes, the couple of meters I have do not have that function....I will use this 10K trick...
Leave a comment:
-
ok. The resistor got hot when I measured the voltage across the high voltage winding....I wanted to see what the reading would be when compared to a non loaded...
Leave a comment:
-
Ok. did a quick check before i go out.....with no resistor across the meter leads I get a voltage reading on 235VAC between one side of the high voltage B+...
- Likes 1
Leave a comment:
-
I will post the voltage readings here later as I have to run out for awhile.......
Cheers.....
Leave a comment:
-
-
OK. I did test it unloaded...I will try the 10K resistor across the meter leads..........
Leave a comment:
Leave a comment: