not sure about wether it fits the hoffman chassis, but I used a hammond 372BX for my tweed deluxe clone (made my own chassis) and it works great...
...
Announcement
Collapse
No announcement yet.
Search Result
Collapse
30 results in 0.0057 seconds.
Keywords
Members
Tags
-
Well some nice folks have been helping me out at the hoffman forum too, here are the results:
...
Leave a comment:
-
ok, I hope this is correct and I'm able to run the two amps, because I fully intend to build it soon......
Leave a comment:
-
Steve I'm the guy who drew it, yes those wires were meant to be connected, the blob is there indeed...
So I have to disconnect those two wires...
Leave a comment:
-
Satamax if you look closely both outputs are there
I though I had done two independent recovery stages? Didn't I?
...
Leave a comment:
-
Reverb with two tanks???
I would like to build an outboard reverb unit (based on the fender 6G15) that would have two reverb spring tanks and two outputs, so that it could feed two...
-
Bruce's sugestion is a good one...
I also saw an amp some time ago, which was around 1w, but I'm not sure wether it was SE or push pull, I'm...
Leave a comment:
-
-
do your 5E3's sound muddy in the normal channel?
My 5E3's are very very dark in the normal channel, it's usable if you plug the right guitar and go for the right settings, but it's still a very dark sound,...
-
for european folks, hammonds are a good bang for the buck I would say... if you're from the ua, you might want to give bruce collins from mission amps a ...
Leave a comment:
-
-
I used the weber bias circuit using the 50 v tap, but also though about using a brownface deluxe type like Bruce sugested... anyway, my opinion is pretty...
Leave a comment:
-
your amp looks amazing dutch... and being able to use diferente front ends is a very cool feature...
my 5e3 still has a major low freq hum...
Leave a comment:
-
some pictures of my homebrew 5e3
here you go when I can I'll post clips, sounds great...
will still had ability to switch first preamp tube bias values and cathode/fixed bias...
-
It's been fixed it was a bad carling switch that was shorting directly to the ground when it was in switched off position...
thanks...
Leave a comment:
-
will do I have to find that short, if it is there.... thanks
btw my house breaker is a 15A...
Leave a comment:
-
Hi i'm in portugal, we have 240 volts over here, the breaker does not go off without a fuse in the amp, only when there is fuse connected...
...
Leave a comment:
-
I did tests to the power transformer, it's ok, and there is no short between the ac line, it only happens in my room, when I go to the garage the amp works...
Leave a comment:
-
Blowing fuses...
With the amp powered off, If I put the plug in the house ac outlet, the electric board of the house instalation imediatly goes off without me even turning...
-
ok bruce I'll do it...
could you also give me a hand with the ground question, which should I use buss or star?
I'm very very...
Leave a comment:
-
I guess I'll leave it out of the equation then... thanks steve
Another question I have is about the ground connections, I'm connecting the...
Leave a comment:
Leave a comment: