Nothing's a fail until you give up. This is an unexpected challenge, not a defeat.
It's a set neck that's harder but possible. Add wood to the...
Announcement
Collapse
No announcement yet.
Search Result
Collapse
184 results in 0.0158 seconds.
Keywords
Members
Tags
-
Sorry, my mistake. Thought you where looking for tube preamp designs....
Leave a comment:
-
Norke, you might try googling "Matchless Hotbox schematic". It's a stand-alone tube preamp. High voltage, but it might be a starting point for what...
Leave a comment:
-
Nevetslab, if you're going to heat epoxy, wear your resperator. Nasty fumes....Last edited by ric; 07-16-2019, 03:10 PM.
Leave a comment:
-
-
Electrical tape's been know to come unwrapped. They make a self fusing rubber splicing tape to go over it.
Edit: Uh, no pun on self fusing either....Last edited by ric; 07-08-2019, 02:11 AM.
Leave a comment:
-
The only "mix" I have to cut thru is a recording or the radio, so this may have no relevance to anyone...
Trying to find a good sounding...
Leave a comment:
-
So the top triode's grid is fed in a familiar fashion. That imposes a signal on the plate that is tied directly to the b+ to the plate load r of the bottom...
Leave a comment:
-
-
I like to run test leads out of the guitar to see which lead I prefer as hot or ground and how the pups play together. I also took an old bakealite antenna...Last edited by ric; 07-02-2019, 02:39 PM.
Leave a comment:
-
Allparts has a selection. I own 2 tele nks and they're playable out of the box. I like to lightly fret level and power buff to re-polish frets and roll the...Last edited by ric; 06-12-2019, 04:36 PM.
Leave a comment:
-
You could run test leads out and try all of this outside the guitar before you commit to anything.
With 6 switches you could wire each pup...
Leave a comment:
-
Wanting to reverse the leads on my tele's bridge pup without unstringing and taking the bridge plate off I ended up with trouble because the lead that had...
Leave a comment:
-
Looks like Lowe's is selling unpainted mill flashing rolls @ 6"x12' for $13 and change/ 6"x50' for $17 and change here in mid Michigan. 24"...
Leave a comment:
-
TE=Helmholtz;529871]I understand the thicker/heavier foil is called flashing, right?
What would you call the alu sheet metal used in Marshall...
Leave a comment:
-
You might want to avoid aluminum foil. Torn or loose foil could be a problem. Aluminum coil stock is available at any home center, sold as flashing.
Leave a comment:
Leave a comment: