Announcement
Collapse
No announcement yet.
Search Result
Collapse
19 results in 0.0037 seconds.
Keywords
Members
Tags
-
4 and 6 to ground is 44.1 and 46.2. No reading on 4 or 6 to 8. Between 8 and 2 is 0.2 ohm.
-
Hi again.
There is no ohm readings on the cathode pin number 8 and ground?
Leave a comment:
-
Hi and thanks again. I have a Ohmmeter, and I'm fairly familiar with it. I shall try to do as you seuggest.
Best.
Leave a comment:
-
Thanks for that, good info. The problem is I don't get any voltege readings close to what I expect, anywher on the board. I don't see any obvious failures...
Leave a comment:
-
Very low voltage on all B+'s.
Hi, Anyone here has a tip on what to look for when the voltage fre the filtercaps in a 5f6a Bassman 59 build is lower than 1 volt? I have checked most thinks,...
-
Thanks to great advice I have now change C1 to .1 uf, C4 to .015 uf and C3 to .022 uf. Different sound already. The treble is respond much, almost like...
Leave a comment:
-
I change to .022 uf, bri
ghter, changed to .1 uf seemed fuller and with less treble?
Where do you think the lowest acceptance for voltage...
Leave a comment:
-
-
-
-
Hi pdf64. Tried to disconnect both, one at the time. One left the amp not sounding and the other left it with a low overdriv and the volumepot not reac...
Leave a comment:
-
Thanks for good advice. All I ask is; Is there on this board any parts that colour the final sound more than others, being in the audiochain so to speak,...
Leave a comment:
-
Ok thanks. I'll just get out of here and visit another friendly place then....
Leave a comment:
-
I see what you mean, but I am looking for a specific tone in the amp. I did this to my tagboard Marshall clone, in that amp there different parts with different...
Leave a comment:
-
I have two Pro Juniors and I am trying to change different values to actually hear the differenc, if any. I have done this also to a Marshall Clone Plexi...
Leave a comment:
-
Tonestack help
Not, it's a tagboard build by Jellyfish Audio after a drawing on another website. It's not a Fender Pro Junior...
Leave a comment:
-
Tonestack help
Thank you, if you could point out the parts that can be altered like resistor Cap values up or down to increase...
Leave a comment:
-
Tonestack help
Hi. I was wondering if anyone here could tell me what would be the "Tonestack" in this Fender Pro Junior setup. I need to tweak the treble/bass...
Leave a comment: