Is CPU death that likely since the PSU didn't have a catastrophic failure? There was no ripple anywhere, only an imbalance of the 8V by a volt.
...
Announcement
Collapse
No announcement yet.
Search Result
Collapse
23 results in 0.0053 seconds.
Keywords
Members
Tags
-
Sorry, I misunderstood this before reading it twice. Tried powering up with only display and power to CPU...Exact same symptoms....
Leave a comment:
-
Update: Finished replacing the caps. All voltages check out good now while disconnected. Fired it up, exact same symptoms. Replaced...
Leave a comment:
-
I have a pile of surplus (Boeing) 125c multi layer 1uf 50v caps. Would it be acceptable to use those in place of the "103's" & "104's"...
Leave a comment:
-
-
This is just too weird.
I reset my thread display mode from hybrid to oldest first.
I still can only go to Pg.4 post #140 when I'm logged in....
Leave a comment:
-
I see that my comment went to page 5.
Anyway, I checked the PSU unplugged first with all good, stable voltages. Then I plugged everything in and re-checked,...
Leave a comment:
-
This might be an easy fix for Admin.
There are 5 pages to this thread. When I sign in, I can only go to this point. This is the bottom of the page...
Leave a comment:
-
Thanks, I'll put it on my parts list.
How about the pair of "stubby" 820uf caps? Not having any luck with Mouser. Tried 1000uf too. Everything...
Leave a comment:
-
This is what I just pulled out of mine.
This is a 100% list of the electrolytics.
2X 820uf @200v
10X 1000uf @16v
6X 1000uf...
Leave a comment:
-
Thanks for this informative thread!
I have a desk with the classic problems described here...
Screen has horizontal lines of random thickness,...
Leave a comment:
-
In reference to a previous comment of mine about solder joint failure and the encyclopedia response I got in defense of a brand that sucks in my opinion....
Leave a comment:
-
Most of the gear that I've worked on has been older amps that have seen years of road use. Usually stuff like XLR jacks and large components that are poorly...
Leave a comment:
-
I respect your knowledge.
I still own one of the first 500 Mackie 24X8's to be released. Never had to replace a fader yet. It does not have the same...
Leave a comment:
-
Understand electrical risks and safety, learn to read schematics, how components act, how to solder/desolder correctly, how to use test equipment correctly,...
Leave a comment:
-
I thought that I remembered having problems with getting the pins to come out of the holes even after they were clean and "cracked loose". The problem...
Leave a comment:
-
Thank you for sharing.
Everything is wavelengths.
Got Chakras?...
Leave a comment:
-
I decided to check and it IS the same mixer. CHRONIC fader failure. First thing that I would check with that mixer. Look for crumbs down in the slots...Have...
Leave a comment:
-
If that's the mixer that I think it is, the faders are designed so the wiper goes right down to the bottom corner of the resistor strip when the fader is...
Leave a comment:
-
Thank you for the valuable info sir! I would assume that you would always want to use dual contacts per channel when using a standard relay in an audio p...
Leave a comment:
-
Leave a comment: