Announcement
Collapse
No announcement yet.
Search Result
Collapse
44 results in 0.0056 seconds.
Keywords
Members
Tags
-
well I'll be ordering some replacement fuses and try again, and follow the peavey biasing recommendations explicitly. at this point, I'm guessing that 60%...
-
the question was not whether amps are sensitive to bias settings or not. the answer to that question is obvious. I may not be the expert that Enzo is, but...
Leave a comment:
-
I carefully unwrapped the outer parts of the transformer and found this device. another view. I checked it with my meter, and found that it is open. I then...
Leave a comment:
-
if you connect it as shown in the second drawing, that 500-ohm resistor will drop a lot of voltage. if that's what you want, that's fine, but normally, the...
Leave a comment:
-
a lot of you guys talk about poor reliability and build quality of these amps, and I've not seen that in them. I have a 333XL that I bought shortly after...
Leave a comment:
-
Fortunately, all of the wires have connectors that only fit in one place inside the amp, so reconnecting it is simple. the transformer is already out, and...
Leave a comment:
-
5150's are known for this issue with their effects loop too. I've seen two myself.
Leave a comment:
-
5150's are known for this issue with their effects loop too. I've seen two myself.
Leave a comment:
-
Peavey Classic 400 Dead PT
a few years ago, I bought a classic 400, and to be honest, it probably had problems right from the start, but didn't actually die until recently. when it...
-
I think it's a pretty well known principle that energy can move much faster than the medium that carries it, is it not?...
Leave a comment:
-
I think it's a pretty well known principle that energy can move much faster than the medium that carries it, is it not?...
Leave a comment:
-
I read the thread on LDRs as pots, and I'd consider it as a fallback solution, but it involves many more components, and for the sake of simplicity, I'd love...
Leave a comment:
-
do you know of any such devices with higher voltage ratings? I can live with 30v, but I'm concerned that a voltage as low as 5.5 would not give me enough...
Leave a comment:
-
digital potentiometers
I have a raspberry pi, and I want to use it to build a digitally controlled tube preamp initially, and eventually adding a power amp. the idea is that all...
-
Low output and distorted sound are two very common effects of a bad OT. a friend of mine had one of these, and his OT went bad after a few months. it was...
Leave a comment:
-
I had this problem with a 5150 a while back. the solution was a new resistor in the preamp heater circuit. can't remember which one, but if memory serves,...
Leave a comment:
-
What exactly do they mean "exclusive rights to the wire"? Are they saying that nobody else can get wire of the same chemical composition that theirs...
Leave a comment:
-
...and sounds as good or better for half the price?
I picked up this amp and cab from a guy in Westland, MI who was basically liquidating inventory...
Leave a comment:
-
I hope the same doesn't happen to me... I'm a lucky hair survivor with a genetic predisposition to losing it. My mom's brother was mostly bald by the time...
Leave a comment:
-
A new resistor fixed it. I wasn't able to get 1/4 watt resistors on short notice, but radio shack had 1/2 watt resistors in stock, which will work just fine....
Leave a comment:
Leave a comment: