Announcement
Collapse
No announcement yet.
Search Result
Collapse
500 results in 0.1898 seconds.
Keywords
Members
Tags
-
I don't know what a Powerball 645-9 is. I only know the two versions (I and II). While the first version has a single common gain control for the clean channel...
- Likes 1
-
I would try removing it to check how long it has been on and if it has left a silhouette underneath (the grill cloth looks very aged). If there is not one,...
Leave a comment:
-
I've had several Rockerverbs and only one with that oscillation (maybe two). I don't remember exactly the system I used, but in that amplifier the "absolute"...
- Likes 1
Leave a comment:
-
I think there is some confusion with the nomenclatures. Peavey 5150 and 6505 heads are electrically identical. Peavey 5150 II and 6505+ heads are also identical...Last edited by Pedro Vecino; 10-11-2023, 11:58 PM.
- Likes 4
Leave a comment:
-
The 6505 and the 5150 heads are identical. The schematic shown is for a 6505 combo (a different circuit). Itīs not valid as a reference.
The 6505 barely...Last edited by Pedro Vecino; 10-11-2023, 10:05 PM.
- Likes 1
Leave a comment:
-
Ampeg? Crate? If so, it's not exactly traditional silicone. It is a less flexible compound with less adhesion. It can be easily removed with the tip of a...
- Likes 1
Leave a comment:
-
I use solder wick almost all the time. I don't know if the difference between bare copper braid and tinned braid has been mentioned here. I exclusively use...
- Likes 1
Leave a comment:
-
Thank you very much Helmholtz. Tomorrow I'll look in my boxes of infinity capacitors and finish it
Leave a comment:
-
Thank you very much to all again. The feedback resistor that Loudthud mentioned is exactly the same one that I first paid attention to as a possibility. But...
Leave a comment:
-
I have not measured it, but guitar in hand the clean channel does not seem to develop all the desirable potential or is at the limit. The amp is new (DSL40...
Leave a comment:
-
Are you using the 8 ohm output? The correct operation of this output depends on the internal contacts of the 16 Ohm output. If these fail, the 8 ohm output...
Leave a comment:
-
Is there a possibility to increase the gain in this circuit? (Marshall DSL40/100)
Hello everyone. This is the circuit that the modern Marshall DSL40/100 uses before the last two switchable master volumes. The output goes directly to the...
Leave a comment: