Wow that really does sound like a Marshall now!
What mods did you do? What speaker are you pumping through?
Sounds sweet!
S...
Announcement
Collapse
No announcement yet.
Search Result
Collapse
49 results in 0.0080 seconds.
Keywords
Members
Tags
-
Sounds really nice but ya something weird going on with the fizzy decay.
Have you swapped out the tubes??
Might check your cabinet as well....
Leave a comment:
-
Any Hot Rod Deluxe Mods out there??
There used to be a great site for this but it's long gone.
Anyone have any tips for modding this amp?
Not looking to take out the PCB just yet....
-
Just got off the phone with Mojo & they don't sell smaller quantities of PU wire than what's on the site. (5 & 8 lbs) Anyone know a good spot to pick...
Leave a comment:
-
-
All the tubes pulled or all but the rectifier??
Was working with it today & put in some new JJ 6V6 & all seems well.
Voltages...
Leave a comment:
-
Too much current in V4
I think I broke my 5E3 build. I'm now getting too much current in the 6V6 beside the rectifier along with flashes inside the tube. The current has dropped...
-
-
-
So are these PU's A5 magnets?? What kind of wire is in them? Formvar??
What size magnets would I need to replace with?
Cheers
Se...
Leave a comment:
-
Thanks for the response.
To clarify...
I don't want to rewind them, I want to wind new ones with new parts.
I'm just wondering...
Leave a comment:
-
AM Standard Strat PU question
I have an 88 & 92 Fender American Standard Strat & was wondering what the specs were on the PU's? What type of magnets/wire/ohm reading etc. I find...
-
Is the Mesa Boogie 5Y3 a re-branded Sovtek??
I just scored a bunch of old 5Y3's at a Hamfest & they all produce the same voltage as the Mesa Boogie....
Leave a comment:
-
-
-
Already built a 5F1 so I was wondering if the 5F2-A has enough difference to make it worth while.
Sean
Leave a comment:
-
5F1 & 5F2-A Much of a tone differenece??
These circuits are so close & they use the same 8 inch speaker. Anyone build them both that can compare?? I have the 5F1 & was considering the 5F2-A...
-
So I'm digging through my supplies looking for a 470 ohm & of course I don't have one. I'm about to make a couple orders from the suppliers & I'm...
Leave a comment:
-
Pin 1 & 2 on the 6V6 are joined & grounded to the lug near the 12AX7.
There was a bit of wire sticking out the back of pin 1 so it looks like...
Leave a comment:
-
A little off topic here but seeing how you've got my 5F1 info above...
What would I need to change to run a 6L6 in this amp?
Cheers...
Leave a comment:
-
What should the current be closer to??
I've tried a bunch & the highest I got was with a JJ 6V6 at 33.6ma.
I get higher...
Leave a comment:
Leave a comment: