Behringer ACX1800 buzz from right speaker

[donnmon]

I've been using this amp for small gigs and its worked fine and quiet until now. I have a buzz(hum) coming out of the right speaker on this two speaker amp...

[HarpCat]

Hi,

I got a Behringer GMX 212 guitar amp in need of a repair and need some help.
There is a low-level 50Hz Buzz on the right speaker...

[kasper]

hi

a couple of days ago my friend gave me his "old" pmp3000 because it dident work (i once repaired his iphone so i must be a tech...

[Rackri]

Hi All
Somebody kindly dumped a Behringer ACX1800 in my yard. Powered it up loud hum then smoke.
I got it to pieces and found one of the output...

[Clay]

Hello,

My Behringer PMP6000 mixer was plugged into 220 volts by mistake and fried. I opened it up to discover the power supply board was damaged....

[clemens72]

Hello,

Recently my Behringer K900FX started fuming during a gig, so I took it home and plugged it in again just for a moment. Fuming started...

[Wayne Leeds]

I have a (nearly) dead DDX3216. Please help me revive it. I am not an electrical engineer. But I have a scope, dmm, soldering station, and some experience...

[Bonediggers]

I was given a Behringer GMX with a broken pc board—the one that holds the input jack. It was destroyed. They tried to change a broken jack. It appears that...

[JacksonMcGinley]

Left monitor section is giving me a lot of static and cutting in and out. Volume will go up and down. Any ideas, please help. Good one day and not the next....

[Mordred]

Hello all,

Nice place you have here. I just registered so I could ask about my PMP980S overheating...

I was using the PA with my...

[Manubol]

Friends please i need your help, I bought a behringer PMP6000 in USA, it is 110V and was connected by error to 240V, a few seconds and smoke, that I might...

[shepo1]

Hi all,
I have a Behringer 18" powered SUB..
Trying to find schematics for it to repair problem with blowing FETS and Driver..
Cant...

[fjdukes]

I have recently come into possession of a BXL1800A. When it is powered up it sounds like an input dead short (the sound you get by grabbing the end of the...

[Robbinsja]

Ok long story short my chord that goes from the Hi/Low inputs to the motherboard has gone bad. I'm having serious trouble with finding the proper parts to...

[Albatross77]

Hi am needing schematic diagram for Behringer Ultrabass BX4210A or something similar for a freind to fix my amp. send to my email if you cant post thanky...

[The David Dude]

Hello all! I need some help troubleshooting a Behringer Europower PMP2000 I acquired used a few years ago.

Sometime within the past year (I...

[gazzini]

Hello, I have a portable epa300 and wonder where to buy amp chips From, I know an electronics engineer who could repair it, but maybe need a service manual...

[technoman28]

Hi folks, newbie here so be gentle!

I have a Behringer Europower PMX2000 mixer/amp, bought it dirt cheap as a non-functionong unit, all looked...

[felstermueller]

Hi Folks,
after reading a lot i finally found this forum with information about the lpa1180 module by behringer. So, i hope, you can help me.
...

[Radial12]

Hi I am new to these forums and am at my wits end, I have a Behringer eurodesk mx3282a, and the external power supply will not power on. Is there any reason...

[topsecret]

The title says it all.
My main out's are not working and the meter lights are all of the way up like a metered channel is clipping.
Nothing...