I don't mean to be dense, but I was initially planning to simply replace the 2-prong cord in my new (to me) '73 YBA-1 w/ a 3 prong cord, run the green wire to the chassis & remove the 'death cap'. I wanted to be sure I was on the right track, so I did a little Google-ing and found this page:
http://www.unclespot.com/2to3prongconversion.html
According to that drawing, I should move the fuse to before the switch & on the 'black' wire. The white wire should just go straight to the transformers. This would require a bit more moving around than I was planning. I took before & 'during' pix to illustrate how my amp is wired. Would someone please take a peek & tell me if I'd be safe/fine just simply hooking the black & white wires back up to the same location they were at on the old wiring (white to top of 120V outlet, black to bottom)?
http://www.unclespot.com/2to3prongconversion.html
According to that drawing, I should move the fuse to before the switch & on the 'black' wire. The white wire should just go straight to the transformers. This would require a bit more moving around than I was planning. I took before & 'during' pix to illustrate how my amp is wired. Would someone please take a peek & tell me if I'd be safe/fine just simply hooking the black & white wires back up to the same location they were at on the old wiring (white to top of 120V outlet, black to bottom)?
Comment