I've got one these on the bench that i've revived. It's got got tubes in it and I biased it up, and one side of this (6) 6L6GC amp, was pulling waaaay more current than the other.
I pulled the board to find burnt trcaes, and a burnt resistor that went across the OC3 regulator tube, for the screens.
My problem is that I can't read the resistor, so I'm not sure how I should go about with a replacement.
I've attached a schematic I found on the net, but all of these amps are inconsistent.
The schematic shows R44 as 10K, across the OC3, but the burnt resistor I'm looking at looks like black, white, red, then some space, then some tolerance band I can't read....but I've never seen a resistor start with a black band
Any ideas on what this resistor should be?
Plush3000B.pdf
I pulled the board to find burnt trcaes, and a burnt resistor that went across the OC3 regulator tube, for the screens.
My problem is that I can't read the resistor, so I'm not sure how I should go about with a replacement.
I've attached a schematic I found on the net, but all of these amps are inconsistent.
The schematic shows R44 as 10K, across the OC3, but the burnt resistor I'm looking at looks like black, white, red, then some space, then some tolerance band I can't read....but I've never seen a resistor start with a black band
Any ideas on what this resistor should be?
Plush3000B.pdf
Comment