Announcement

Collapse
No announcement yet.

Lace Alumitone Deathbucker wiring help!

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Lace Alumitone Deathbucker wiring help!

    Hi folks, please i need your help about wiring this Deathbucker to a CTS push pull 250K. A "luthier" wired It improperly because it's causing a lot of noise and It sounds very muddy. I know how to solder but i have never wired a CTS push pull. It's only one humbucker and one volume (the CTS is gonna be the volume control) and the tone pot is attached to a 220 Orange capacitor. Please help

  • #2
    Maybe a mod could move this to the guitar tech section where it might get more action?
    Originally posted by Enzo
    I have a sign in my shop that says, "Never think up reasons not to check something."


    Comment


    • #3
      Agree with g1.

      Add: There are lots of ways to wire a push pull switch- coil tap, series coils, phase reverse, etc., etc. It would help if you said what you want the switch to do, what kind of switch it is (SPST, DPDT, etc.), and provided a wiring diagram of the pickups.
      "I took a photo of my ohm meter... It didn't help." Enzo 8/20/22

      Comment

      Working...
      X