Well, I've done it again. I have a Behringer X2442USB mixer that had a loud hum, which suggests the power supply. After I took it apart, I discovered that the 1000uf and 470uf caps were bad (bulging). Since I didn't have them in stock, I ordered them and received them four days later. Changing the caps solved the problem. Now the problem is, I have 8 screws left over. Normally I take pictures to remind me which screw goes where. I thought it would be obvious since there are only two thread sizes, and some are painted black. I have eight screws for which I can't find a place to install. See below.
I haven't screwed up like this in years. The next time I take a Mackie or Behringer mixer apart, I'm going to do it in front of a video camera. If you know where these flat head screws go or where a service or parts diagram is for this mixer, please share. The repair was pretty trivial, but the reassembly is not.
Thanks
I haven't screwed up like this in years. The next time I take a Mackie or Behringer mixer apart, I'm going to do it in front of a video camera. If you know where these flat head screws go or where a service or parts diagram is for this mixer, please share. The repair was pretty trivial, but the reassembly is not.
Thanks
Comment