Wrong value for screen resistors on Hot Rod Deluxe - will this matter?

[Kindly Killer]

I had R62 on my Hot Rod deluxe burn up, I presume because of a bad tube. http://www.elektroda.pl/rtvforum/dow...=322434

I cleaned up the carbon, installed 510Ohm 1W resistors for R61 and R62 because it was the closest value I had on hand. Schematic calls for 470 1W, and that is what was in there, according to color code at least...

Will that make a big difference in sound, longevity, etc? Will that thow off the number I get at the test point to bias the new tubes?

I dread taking apart that whole thing again. At some point I'm going to break something muscling those PCBs in and out, and my troubleshooting skill isn't very good...

[frus]

It will be exactly the same, don't worry. The screen resistor value is not at all critical, maybe you would have noticed some difference in tone if you put, say, 2k

[Kindly Killer]

great. Thanks!

[Gingertube]

I would have fitted 1K 5Watt as a matter of routine. Added protection for the output tube, a little more compression in the power amp (which you probably won't notice). Every 6L6 I ever see gets this done to it. Never had anyone even comment on a sonic change.
Cheers,
Ian