Ground Question

[trem]

...for example.
Since the B+ for the Trem Tube comes off the Screen Supply.....is there anything wrong with grounding the...Trem foot switch jack to the same ground as the filter caps for the Plates and Screens...and then ground the Trem Tube Cathode to the solder lug on that foot switch jack.?
Thank You
Prowess Amplifiers - Ampeg - Schematics - M12 6v6

[uneumann]

...for example.
Since the B+ for the Trem Tube comes off the Screen Supply.....is there anything wrong with grounding the...Trem foot switch jack to the same ground as the filter caps for the Plates and Screens...and then ground the Trem Tube Cathode to the solder lug on that foot switch jack.?
Thank You
Prowess Amplifiers - Ampeg - Schematics - M12 6v6

This may be too late... but since no one answered, I'll take a stab. Your diagram didn't load so I can't see the exact circuit, but in principle, you're exactly right... A good grounding scheme will allow current to flow from the power side of a filter cap to the ground side of that cap. The less cross interference with other sources and grounds (returns), the better. If you want to use the jack lug as a tie point, it's probably OK since it's a trem circuit, not a preamp, but its better to star-tie all the return currents to the source cap ground.

[trem]

Better late than never.....
No rpoblem. It was really a question of proximity.
The FS Jack was the tidiest and most direct ground path.
At any rate, it worked out fine.
Thanks for the advice.
best