damaged cap

[john t]

I put a very small nick in the outer rap of a malory150 cap with the iron while installing on my 5e7 board. Is there any need for concern. It is a very small nick, I would rather not replace if is not nessasary.
Thanks John

[Bruce / Mission Amps]

Ha ha... for a dollar cap and what it can do to you later if it fails, dump it anyhow.
Bruce

[john t]

bad cap

Thank you for the reply Bruce. I will order a FEW extra caps, Just incase. It was not the dollar I minded. Every time I pull out a part it seems it never goes back in place as nice as the first time. Then again, based on your comments If the cap takes out other components I will have a bigger mess to content with. PS could not find cap prices on the web site.

Thanks.

john T

[Bruce / Mission Amps]

I'll just give you couple M150s for nothing adn toss it in with those tubes you needed.
It just takes a little practice to get in close and keep the shoulder of the solder tip away from the cap bodies.
Bruce