Crate GX-1200 - Problems persist after new parts

[g1]

Dude and G1. Lets do this the diplomatic way.
Do I replace IC3 again ( may have blown it but no supporting evidence). or float the final emitters.

Al

Both of us said to float the emitters, in agreement with your earlier question. It's like you are not reading the posts here.
I assumed you had the emitters floating, had the variac at full line voltage, and have + and - 1.4V at IC3 outputs.
But you do not respond to confirm.
If we do not know the operating conditions it is impossible to advise.

[skidmark]

Ok, all 4 emitter resistors are clipped and I can run it up to full AC voltage. The amp is now drawing about 180 mils of AC current idle.
I'll start some DC measurements soon. Gotta entertain some grandchildren for a bit.
I'll post the all the readings in the next post.
Al

[skidmark]

Just found broken pc run between R61 and IC3 pin 8.
Standby ...