i know this is really pretty lame newbie issue but hoping someone can give a little advice on this one.
I ran a champ [5f1 circuit] for a couple minutes on standby and then switched to full power with no speaker load. foolishly i forgot to connect the speakerbox.
i connected a speaker after powering down then standby> power on and it seems to be running ok
my question is whether under this scenario, is any damage likely to have occurred? and if so what component would be involved and what signs should i be watching for ?? ie more hum? overheating$, tubes blowing?, blowing fuses?
thanks
I ran a champ [5f1 circuit] for a couple minutes on standby and then switched to full power with no speaker load. foolishly i forgot to connect the speakerbox.
i connected a speaker after powering down then standby> power on and it seems to be running ok
my question is whether under this scenario, is any damage likely to have occurred? and if so what component would be involved and what signs should i be watching for ?? ie more hum? overheating$, tubes blowing?, blowing fuses?
thanks
Comment