i just wired up the filament pins on my tube sockets, being very attentive to polarity on the preamp tubes. when i soldered the 6.3v wires from the transformer to the filament pins, i rechecked and i had no resistance (.3r exactly) between pins 4/5 & 9 of a 12ax7. i disconected the transformer wires and tested them. i heard the continuity buzzer from my multimeter!
is there supposed to be continuity between the two green 6.3v wires??
the transformer was not bad a day ago when it was in another amp. all i did different was twist the wires. could i have damaged the transformer or am i just being paranoid? i'm afraid to power it up and find out for myself.
is there supposed to be continuity between the two green 6.3v wires??
the transformer was not bad a day ago when it was in another amp. all i did different was twist the wires. could i have damaged the transformer or am i just being paranoid? i'm afraid to power it up and find out for myself.
Comment