I recently had a bass player over to jam with and loaned him my Traynor YCV20. He forgot to use the standby switch when starting up. In the past, this has caused the reverb to not work until the amp is cooled off and re-started. I got the reverb to work once after he left, but now it is not working.
I know the reverb is connected properly because I can thump the reverb assembly and get sound back through the speakers, properly modulated by the potentiometer dial.
What could cause the reverb to stop getting a signal whenever the amp is started up without letting it warm up first in standby mode?
They always warn you not to do that!
I know the reverb is connected properly because I can thump the reverb assembly and get sound back through the speakers, properly modulated by the potentiometer dial.
What could cause the reverb to stop getting a signal whenever the amp is started up without letting it warm up first in standby mode?
They always warn you not to do that!
Comment