Ad Widget

Collapse

Announcement

Collapse
No announcement yet.

problem with Bluesbreaker voltages - help...

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • #16
    Originally posted by Enzo View Post
    You can run a lead over to a ground point. Remember you are not grounding something in the signal circuit, you are only grounding a shield.

    What is the voltage across the standby switch when it is OFF? If you put a cap there, it better bave a higher voltage rating than what you find there.

    Pops are not necessarily from the switch arcing. The tubes are hot, and when teh switch is flipped there is a large current surge as caps fill up and voltages rise quickly in the circuits. The tubes amplify that into a pop.
    Enzo,

    in standby the switch has 360v on it. in 'play' mode it's got 418v.

    It's been suggested that I put a 0.047uF cap from the cold side of the switch to ground but there isn't a convenient ground point where the standby switch is located.

    Would a thermistor/surge-guard cure the popping if I connect it between the hot side of the switch and the B+ feed to the circuit?

    HTH - Heavier Than Hell

    Comment


    • #17
      Little caps generally go across the switch contacts, not to ground. I do not generally "fix" standby switch pops, since they are normal and a fact of life.
      Education is what you're left with after you have forgotten what you have learned.

      Comment


      • #18
        Cheers Enzo,

        The amp doesn't seem to be popping at the standby switch now anyway so it's not even an issue anymore.

        I'll keep that info in my files.

        HTH - Heavier Than Hell

        Comment

        Working...
        X