Hey everyone,
I have a 333Xl combo for a little over a year now. I haven't used it very much (thanks to our lovely economy). In the last month or so I noticed on 2 occasions at rehearsal after it was on for about an hour it started to produce a 60 htz hum or buzz.
Now it does it every time I turn it on. It is proportional to the volume level. If the volume is all the way off the hum goes away with it. It does it on every channel.
The amp still amplifies and sounds normal but has this annoying buzz that won't go away.
I verified that the Melting Molex connector had been hard wired at the factory.
I swapped out all of the power tubes. (with used El34's). I swapped out the pre amp tubes one by one, I tried a different cab..no luck.
I took a look inside and didn't notice any burnt wires or components.
I checked the solder joints at the tube sockets and they seem ok.
I didn't remove any of the boards to look under them.
Does this sound familiar to anyone?
I have a 333Xl combo for a little over a year now. I haven't used it very much (thanks to our lovely economy). In the last month or so I noticed on 2 occasions at rehearsal after it was on for about an hour it started to produce a 60 htz hum or buzz.
Now it does it every time I turn it on. It is proportional to the volume level. If the volume is all the way off the hum goes away with it. It does it on every channel.
The amp still amplifies and sounds normal but has this annoying buzz that won't go away.
I verified that the Melting Molex connector had been hard wired at the factory.
I swapped out all of the power tubes. (with used El34's). I swapped out the pre amp tubes one by one, I tried a different cab..no luck.
I took a look inside and didn't notice any burnt wires or components.
I checked the solder joints at the tube sockets and they seem ok.
I didn't remove any of the boards to look under them.
Does this sound familiar to anyone?
Comment