Tweet
Anyone know what the optos used in the "super" series were? They're not marked in the schemo and these things are a huge PITA to get the pcb out of. Got a bad one in the clean section that works ok for a while then all hell breaks loose....passes distorted signal and tons of crackley noise when it shouldn't. This is with the vol full down. OD ch works fine. These are a bit goofy looking as the resistive side is center tapped.
-
The farmer takes a wife, the barber takes a pole.... -
From the parts list - VTL5C3/2
Here is the full file.Education is what you're left with after you have forgotten what you have learned. -
Cool beans. Looks like they're all on the front panel board too....good. I didn't wanna have to yank out the main pcb....The farmer takes a wife, the barber takes a pole....Comment
Comment