I have this magnificent Peavey Transformer 212, it just has a small issue.
The program Knob, which cycles around my stored configurations, stopped working.
It has this ring of LEDs around the knob and on the one it's active it's lighted, and before the problem, if i turned the knob it cycled, now it doesn't happen.
Randomnly it works, randomnly it stops doing so. And if it works is for only 2 or 3 steps.
What can I do?
The program Knob, which cycles around my stored configurations, stopped working.
It has this ring of LEDs around the knob and on the one it's active it's lighted, and before the problem, if i turned the knob it cycled, now it doesn't happen.
Randomnly it works, randomnly it stops doing so. And if it works is for only 2 or 3 steps.
What can I do?
Comment