Epiphone EA-50T Pacemaker Power Transformer

[imbuedblue]

I have an Epiphone Pacemaker on the bench with a blown PT. It is stamped TF-105-P. Does anyone know of a drop-in replacement?

Here's a link to the schematic:

http://silbatoneacoustics.com/images...makerTDPRI.jpg

[Micajah]

RE: TF-!05 P Transformer

I know this is an old post but I have the same question. Did you find a replacement other than the 125.00 Mercury Magnetics?

I have an Epiphone Pacemaker on the bench with a blown PT. It is stamped TF-105-P. Does anyone know of a drop-in replacement?

Here's a link to the schematic:

http://silbatoneacoustics.com/images...makerTDPRI.jpg

[52 Bill]

I know this is an old post but I have the same question. Did you find a replacement other than the 125.00 Mercury Magnetics?

I don't know if this will drop in place, but look at the EDCOR XPWR013. 510vac ct @125mA and 6vac ct @4 amps.

I've used the Edcor transformers to replace Gibsons before, but I have had to replace the end caps so that the transformer would mount in the correct lay down position.

[Jazz P Bass]

Beat me to it, Bill.
https://www.edcorusa.com/xpwr013

[Micajah]

EA-50T Transformer links

I don't know if this will drop in place, but look at the EDCOR XPWR013. 510vac @125mA and 6vac @4 amps.

I've used the Edcor transformers to replace Gibsons before, but I have had to replace the end caps so that the transformer would mount in the correct lay down position.

Thanks - I'll check it out.
After searching for the Schematic - I found a link to the Gibson GA- 5T which is the Gibson version of this model or should I say the Epiphone is a version of the Gibson Model.
Identical circuits. Here's the link at Gibson Garage.
Gibson Garage - Amps
By the way what speakers are you guys running with the EA-50T
Thanks
Micajah?

[Micajah]

I don't know if this will drop in place, but look at the EDCOR XPWR013. 510vac ct @125mA and 6vac ct @4 amps.

I've used the Edcor transformers to replace Gibsons before, but I have had to replace the end caps so that the transformer would mount in the correct lay down position.

Sorry forgot to ask - did you use the bells from the factory transformer? Or?

[52 Bill]

Sorry forgot to ask - did you use the bells from the factory transformer? Or?

The one that I can remember, I used the original transformer outer end bell, so from the outside it looked original.

[CONSULTRIX]

I know this is late but i have one of these with a "missing" pt, so i called phil
at heyboer trans in mich and he wound one for me. They are no longer in stock
and i have gotten quite a few other transformers from him and he was nice
enough to wind one for me on his own time, but what a nice gesture. Took
about six mo but hey, nice real exact unit. Hope he doesn't mind me saying this.
Dave.....good luck anyone!