Ad Widget

Collapse

Announcement

Collapse
No announcement yet.

Vibro Champ Indicator Lamp Wiring

Collapse
X
Collapse
 
  • Page of 1
  • Filter
  • Time
  • Show
Clear All
new posts
Previous template Next
  • #1

    Vibro Champ Indicator Lamp Wiring

    Just finished replacing electrolytics and a three prong power cord upgrade using twisted heater pair with 100 ohm resistors to chassis ground.

    Everything works fine and the amp is quiet, but does anyone have a creative way to rewire the stock indicator lamp?
    Tags: None
  • #2
    one end of the 6.3V wind to one lamp terminal and the other end of the 6.3V wind to the other lamp terminal. It's still a 6.3V lamp. The last VC I changed to a twisted pair had the two 100R resistors on the lamp socket with their junction wired to the top of the 6V6 cathode resistor for a little DC elevation as well. Zero hum.
    "Take two placebos, works twice as well." Enzo

    "Now get off my lawn with your silicooties and boom-chucka speakers and computers masquerading as amplifiers" Justin Thomas

    "If you're not interested in opinions and the experience of others, why even start a thread?
    You can't just expect consent." Helmholtz

    Comment

    • #3
      It was wired with a single lead and I didn't realize both sides of the lamp were isolated from the lamp frame until I spotted the base terminal secured to the frame covered under solder. Unfortunately I found it after posting.

      Thanks Chuck.

      Comment

      Previous template Next
      Working...
      X