Sope question

[bsco]

I think there have been a few mentions of the feedback resistor, but I'm not sure if you tried disconnecting the feedback loop?

P.S. I think it would be negligent if I didn't mention that the proper spelling is soap.

Hahaha....I know.....OK. Here is what we finally have.....I somehow have managed to get the clean channel working good...not quite sure what I had done.....but before I started it was horrible.......I decided to plug in a speaker instead of the dummy load just for a check.....maybe moving leads around might have done it......I did change bypass caps as well.....maybe that was also Part of it.....but for some reason, my scope is causing these weird complex waveforms and I couldn't figure out why even the signals at the plates of the output tubes were good as well.....so it had to be past that point....anyway....now I have an extremely low volume in the tremolo channel....the clean channel is fine....nice and loud........so I am finally getting somewhere.....I have used my scope on other vacuum tube amps before with a dummy load and never encountered this problem before....anyway....now to fix up the tremolo channel.........Thank you "EVERYBODY" for putting up with me......I will let you know what I find.........