Marshall VS-265 reverb not working

[baumtracks]

Has anyone heard of problems with reverb with the Marshall valvestate VS-265? If so do you know how to correct it? Thanks!

[Enzo]

ANY amp with a reverb can have a failure in the reverb circuits. There is nothing special about this one.

You pull the reverb pan and see if either end is open. You check the cables between pan and circuit board.

You power up the amp and set the reverb in the middle, then touch the tips of the two cables. One should hum - that is the return and should go into the jack marked OUTPUT on the pan. The other cable is the drive and there should be signal there. feed it to another amp or a small speaker to see.