Marshall DSL 50 making me very frustrated

[Jazz P Bass]

Quote:"the issue I have with connectors is where is the drawing of the other end of the 6 pin Con4 in the relay coil circuit?"


Con 4 goes to the rear board/ foot switch circuit Con 5.

This is a crop of the DSL100 which uses a DIN connector (ignore that)
The DSL50 drawing that I have for the rear board is hard to read (fuzzy)

tl106202_Con 4 to Con 5 Rear Board.pdf

[Randall]

Thanks Jazz P, that connector just goes to the foot switch jack, so no revelation there. I'm going with if I can't hear RL1 clicking with a stethoscope like I can RL2, and they are in series, and the LEDs are working, then RL1 isn't working. I ordered one today, we shall see. I will report back next week. Thanks for the help guys, as always.

[Randall]

Alas, replacing relay 1 on the front panel board, the one in series with relay 2 and the LED that were both functioning, fixed the issue. The crunch button and Gain pot both now work. A very frustrating and time wasting repair due to the confusing documentation from Marshall on this. But thank you so much for the help on this one, as always, the amp goes back on stage.