Tweet
I have OK readings at TP18 (63mVAC)
I have 3mVAC @ TP19. backtracking from there, I have 0mVAC at either end of R18 and R19.
This leads me to believe that there is signal going into the DSP board OK and none coming out therefore bad DSP board and this is a donor chassis/iron project (which to me is not a bad thing.)
Agree? If so, the PCB's will be gutted and this will become a fun project. Was hoping I could get it to work though.
Schematic can be found in this thread... http://music-electronics-forum.com/t32795/
I have 3mVAC @ TP19. backtracking from there, I have 0mVAC at either end of R18 and R19.
This leads me to believe that there is signal going into the DSP board OK and none coming out therefore bad DSP board and this is a donor chassis/iron project (which to me is not a bad thing.)
Agree? If so, the PCB's will be gutted and this will become a fun project. Was hoping I could get it to work though.
Schematic can be found in this thread... http://music-electronics-forum.com/t32795/
Comment