I have a crate amp where 2 pots are defective and need to be replaced. Unfortunately I cannot locate these pots anywhere and need ideas on how to repair.
The existing pots are mounted to the pc board and sit freely on the board and pass through the faceplate but are not mounted to the face plate.
I know that they are 10k pots and was thinking is it possible to remove the offending pots and solder 3 wires to the board and run them to any old 10k pot that is mounted to the faceplate.
Its been over 30 years since I worked as a technician so not familiar with current solutions or trends and checking to see if may be other solutions.
Thanks for any help here
Kenru
The existing pots are mounted to the pc board and sit freely on the board and pass through the faceplate but are not mounted to the face plate.
I know that they are 10k pots and was thinking is it possible to remove the offending pots and solder 3 wires to the board and run them to any old 10k pot that is mounted to the faceplate.
Its been over 30 years since I worked as a technician so not familiar with current solutions or trends and checking to see if may be other solutions.
Thanks for any help here
Kenru
Comment